The Flex2Go Mobile Voice and 3G Signal Booster Kit for Boats and other Marine Vehicles (SC-DualM-50-RV/DK-KIT) will boost the 2G and 3G networks from all major carriers throughout the inside area of your boat. The Flex2Go Marine kit features an interior right angle antenna to broadcast the boosted signal to the inside of the boat, so multiple phones and mobile devices can take advantage of the boosted signal simultaneously. The 50 dB amplifier is the most powerful mobile booster allowed by the FCC, so you can get the best boosting signal wherever you may be.
This Flex2Go Marine Kit includes everything necessary for installation in your boat, including an outside weatherproof omnidirectional antenna, 40 ft coax cable, the Flex2Go amplifier, inside antenna, and both and AC and 12V DC power supply.
Looking to boost WiFi in your Boat or Marine Vehicle? Our Hawking Marine Wireless Smart Repeater with 15dBi Omnidirectional Antenna will allow you to connect to a WiFi network up to 6 times the distance away and increase the coverage area by up to 3 times.
The Flex2Go Marine Signal Booster Kit supports the Voice and 3G networks from all major carriers in North America. It does not support any LTE, WiMAX or iDEN networks. The following carriers are supported:
- AT&T 2G, 3G & 4G HSPA+
- Verizon 2G & 3G
- Sprint 2G & 3G
- T-Mobile 2G, 3G & 4G HSPA+
- US Cellular 2G & 3G
- All other carriers using 800 MHz, 1900 MHz
Mobile signal boosters are restricted to a relatively low power to limit the chances that they could interfere with a cellular network. With a max gain of 50 dB, a mobile signal booster can cover about 10 ft from the inside antenna, when you have a moderate to strong existing outside signal. When you have a very weak existing outside signal, the coverage area may be limited to just a few feet around the inside antenna. For best results, we recommend leaving your phone or data device near the signal booster's inside antenna and then using a bluetooth headset for phone calls while in your boat or marine vehicle.
The Flex2Go Marine Kit includes everything necessary for a standard installation, including the following:
- SureCall CM288W Full Band Fiberglass Omnidirectional Antenna
- SureCall 40 ft Ultra Low-Loss CM240 Coax Cable (SC240-40FN)
- Flex2Go 50 dB Dual-Band Amplifier
- Interior SC-120W right angle antenna
- DC Power Supply with 6' cable
- AC Power Supply
- Screw and Velcro mounting kit
|Max Coverage Area||6 Foot Radius|
|Specific Frequency (Up/Down)||824 - 849 MHz / 869 - 894 MHz, 1850 - 1910 MHz / 1930 - 1990 MHz|
|Gain||50dB / 50dB|
|Power Requirements||DC 5-15 V - <10W|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.