The Wilson 4G LTE Signal Booster Kit for Verizon Wireless includes everything necessary to boost a Verizon 4G LTE signal in your home or office. 4G LTE is only used for data traffic and will not boost the signals required to make and receive phone calls. For a Verizon LTE kit that also boosts 3G signals and improve phone calls, check out the Wilson 845163 Tri-Band 4G-V Premium Kit for 3G & Verizon 4G LTE.
- 1 Wilson 4G LTE 70dB Amplifier for Verizon Wireless (801865)
- 1 Wilson Multi-Band High Gain Yagi Outside Antenna (304411)
- 1 Wilson Dual Band Panel Inside Antenna (301135)
- 2 Wilson 50' Ultra Low Loss Coax Cables (952350)
This system will not boost any signal other than Verizon 4G LTE and does not work for AT&T 4G or any carrier's 3G networks.
Wilson 4G LTE Amplifier for Verizon Wireless (801865) Installation Video
|Max Coverage Area||Up to 10,000 sq ft|
|Specific Frequency (Up/Down)||776 - 787 MHz / 746 - 757 MHz|
|Gain||70dB / 70dB|
|Power Requirements||110-240 V AC, 50-60 Hz, 10 W|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.