Boosting the cell phone reception over a large area requires high quality, powerful boosting equipment. Luckily, Wilson Electronics offers one of the best kits on the market to make it easy for you to do just that. The Wilson AG PRO 70 Omni Kit comes complete with everything you need to get started with increasing coverage in your area. The equipment supports dual bands, so it will work with most North American service providers, except for Nextel.
- Wilson 801265 AG PRO 65/70dB Amplifier
- External 301201 75 ohm building antenna
- Internal 301155 panel antenna
- 20ft, 30ft, and 50ft RG6 coaxial cables and barrel connector
- Instruction manual with installation directions
|Max Coverage Area||Up to 7,500 sq ft|
|Specific Frequency (Up/Down)||824 - 849 MHz / 869 - 894 MHz, 1850 - 1910 MHz / 1930 - 1990 MHz|
|Gain||65dB / 70dB|
|Product Manual||Signal Booster Installation Guide (PDF)
External Antenna Installation Guide (PDF)
Internal Antenna Installation Guide (PDF)
|Product Specifications||Signal Booster Spec Sheet (PDF)|
|Power Requirements||110-240 V AC, 50-60 Hz, 8 W|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.