The SureCall EFlex Pro 65 Premium Panel Signal Booster Kit (CM-EFLEX-65-YAGI-PKIT) is a powerful dual-band signal booster kit designed for homes and small offices. The EFlex-65 can boost a signal over an area of up to 10,000 sq ft depending on the outside signal strength. For maximum performance, the EFlex-65 Kit requires at least 50 ft of horizontal or vertical separation between the inside and outside antennas.
Unlike the original SureCall Flex Pro 65 Kit, this kit features a directional outside antenna which must be aimed, so it will only boost the carriers with towers in the same general direction. While an omnidirectional antenna can cover multiple carriers simultaneously, a directional antenna is more powerful and can double the coverage area of a signal booster when compared to an omnidirectional antenna. If you have a strong outside signal and you need to boost multiple carriers, you should go with the original omnidirectional EFlex Kit. This kit also features a panel inside antenna which is best for covering multiple floors or long and narrow spaces. For a single floor, our EFlex Premium Kit with a dome antenna may work better.
The directional outside antenna included in this kit comes with two U-Bolts for pole mounting. If you do not have an existing pole, typically used for TV antennas, you will need a small pole mount.
The SureCall Flex Pro 65 Adjustable Signal Booster Kit boosts the standard dual-band frequencies of 800 and 1900 MHz which are widely used in North America. The following carriers are supported:
- AT&T 2G, 3G and 4G HSPA+ (not 4G LTE)
- Verizon 2G and 3G
- Sprint 2G and 3G
- T-Mobile and Cricket 2G
- Virgin Mobile 3G
This system does not support LTE, WiMAX, Nextel/iDEN/MIKE, or AWS networks.
Included in the Kit
|Max Coverage Area||Up to 10,000 sq ft|
|Specific Frequency (Up/Down)||824 - 849 MHz / 869 - 894 MHz, 1850 - 1910 MHz / 1930 - 1990 MHz|
|Gain||65dB / 65dB|
|Product Manual||EFlex-65 User Guide|
|Product Specifications||EFlex-65 Data Sheet|
|Power Requirements||Input AC110V, 60Hz; Output: DC12V/6V|
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider's consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider. WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device.
Please note, the four largest carriers - AT&T, T-Mobile, Verizon and Sprint - and more than 90 regional carriers have given blanket consent for use of all boosters certified to the new FCC standards.